Since my network infrastructure will not change often, a static IP address works great in this scenario. I also know the what the fixed IP address will be, and I do not have to browse to my router web admin page to find the IP address of the switch. The reason I use a static address is so that I can connect to the switch and configure it before I connect it to the rest of the network (which is important if you are using link aggregation, for instance). I am choosing in this example to use a static IP address rather than one dynamically assigned by my router. Therefore the default IP of the switch will need to be changed so that the web administration page can be accessed. If your network preference is similar to mine, I use the default LAN subnet of 192.168.1.0 as my management VLAN. You should change those defaults ASAP, of course, for security reasons. Log into the the web administration page by visiting with the default username:password of admin:admin. Since the default IP address for the switch is 192.168.0.1, you should set your IP address within the same subnet (192.168.0.2 - 192.168.0.254) so that you may access the web administration for the switch. The switch does not have DHCP enabled by default so you will need to manually enter your IP address in your computer. The switch does not need to be plugged into other network device such as a router until the initial configuration is completed. To begin configuring the switch, first plug a desktop or laptop computer into any port in the switch. I am assuming the switch is currently configured with the default settings from the factory. To show the difference between the firmware versions. Hold the restart button for 10 seconds.In this how-to, I will using the TP-Link T2600G-28TS L2 managed switch (affiliate link)Īnd the TP-Link T1500G-10MPS PoE smart switch (affiliate link) The router- PC connection has network issues.The Incorrect IP address is used in the browser or wrong settings are set up.The default IP address is not configured properly.If you are facing issue while connecting Router then these could be the possible issues. Step 3: Enter default username and password as mentioned above. Step 1: Connect your TP-LINK Router with the PC with the RJ45 cable. Step 3: Enter Router’s default username and password. Step 2: Open any web browser and type 192.168.1.1 > Enter. Step 1: Plug Netgear router with your Windows PC Now type in default username and password. Step 4: D-Link router administrator will pop up. Step 3: Open any web browser and type and press enter Step 5: Cisco Router Admin Page will open and now you can all the required settings for usage. Step 4: Enter Cisco default username and password (admin-admin) Step 3: Open any Browser and type 192.168.1.1 and press Enter. Step 2: Connect the adapter and turn on Router and PC. HOW TO SETUP CISCO ROUTER USING 192.168.1.1 Hurray! IP ADDRESS OF VARIOUS ROUTERS WITH DEFAULT USERNAME AND PASSWORD: Router Manufacturer Login to your router admin page with username and password > go to advanced settings > Router Admin > Change Password > Enter the old password and New Password and save. Setting up a new router or to configure your network requires a router IP Address which leads to login details of your router. You should use an updated encrypted hard password for WPA2 and PSK to make the Wi-Fi safer. Default username and password for most routers are:įurther, you should enable WPA2 and PSK for the Wi-Fi security.
0 Comments
Leave a Reply. |